- Uses of a vernier or caliper
- 1- Measurement of pipes
- 2- Measurement of nuts and bolts
- 3- Symmetry check
- 4- Separation between objects
- 5- Thickness
- References
A vernier, also known as a caliper or caliper, is a precision tool used to measure small lengths with a minimal margin of error. It consists of two components, one fixed and one mobile; the ruler and the slide.
The ruler is the fixed part and consists of a piece of metal marked with a scale in centimeters and millimeters. One of its ends forms a double-sided jaw that engages with the slide to make measurements.
The slide is the moving part of the vernier. It is calibrated in millimeters and slides through the ruler to complement the clamp. The degree of opening of the jaw is measured thanks to the slide.
Uses of a vernier or caliper
The vernier is an instrument commonly found in construction and industrial contexts. Although the most common is to find manual gauges, like the one described above, they also exist in a digital version.
Its operation is the same, but instead of reading the length with the scale, it is expressed numerically on a digital screen.
1- Measurement of pipes
Perhaps the greatest utility of the vernier is the measurement of tubes and pipes. Due to their cylindrical shape, these items are difficult to measure accurately with a traditional tape measure.
In this case the jaw has double function, it can be used to measure the external and internal diameters easily.
For the external side it will be enough to open the vernier and close it until it tightens the pipe. For internal diameters the slide is closed and then opened until the rear ends of the jaw touch the inside of the tube with both sides.
2- Measurement of nuts and bolts
When adjusting a nut or screw, it is also proceeded to surround them with the internal ends of the clamp, proceed to close the vernier and then to verify the measurement.
In the event that the inside diameter of a nut must be measured (to verify that it is wide enough to be screwed in), the same method is used as with tubes.
The vernier is closed, the rear side of the clamp is inserted into the nut and then it is opened until the measurement is obtained.
3- Symmetry check
In industrial areas, it is repeatedly necessary for rotating tools to be perfectly symmetrical to avoid unbalances, such is the case with lathes and drills.
The vernier can be used to measure the width of the wicks at various points, and thus check if it is constant.
4- Separation between objects
Many mechanical and electrical parts only work when separated by a specific distance. To obtain the highest possible precision, the vernier is frequently used.
Just open its jaw and close it until you get a measurement.
Both the manual and digital verniers express measurements down to hundredths of a millimeter.
5- Thickness
In construction, walls and walls are usually built that must have a minimum or maximum thickness.
The vernier can easily measure this distance and slide along the height of the wall to check that the thickness is uniform.
References
- How To Read A Vernier Caliper (nd). Retrieved on October 9, 2017, from Mini Physics.
- V. Ryan (2004). The Vernier Caliper. Retrieved on October 9, 2017, from Technology Student.
- How to use a caliper or caliper (October 19, 2016). Retrieved on October 9, 2017, from DIY Workshop.
- Francis T. Farago, Mark A. Curtis (1994). Handbook of Dimensional Measurement.
- Vernier caliper (June 4, 2014). Retrieved on October 9, 2017, from Encyclopædia Britannica Workshop.